ITI Knowledge Base

Setup Checklist - Motion-Base Station

Make sure you check all the boxes and get started on your ITI VR training journey!

Power

  1. ☐ Laptop power cable
  2. ☐ Motion Base power cable
  3. ☐ Cables plugged into dedicated 110v outlets
  4. ☐ Touch Controller batteries

Sensors

  1. ☐ Sensor lenses clean and undamaged
  2. ☐ (if pre-calibrated) Left / Right sensors identified
  3. ☐ Sensors securely fastened to tripod
  4. ☐ Tripod placed approx. 2 ft. (24in.) in front of foot pedals
  5. ☐ Sensors straight and centered towards operator

Cables

  1. ☐ USB 3.0 Hub [connect to laptop USB port left side]
  2. ☐ Sensor cables [connect to laptop USB 3.0 ports right side]
  3. ☐ Oculus HDMI cable [connect to laptop left side]
  4. ☐ Oculus USB cable [connect to USB hub left side]
  5. ☐ Sim USB cable [connect to USB hub left side]
  6. ☐ HDMI to Mini-Display Port display cable [left side]

VR Headset

  1. ☐ Cable not showing cuts or other damage
  2. ☐ Lenses clean
  3. ☐ Screen displaying properly
  4. ☐ Confirm no visual lag/latency with movement

Secure Hardware

  1. ☐ Controller pods securely fastened [not wiggling]
  2. ☐ Motion Base support arms secure [not wiggling]
  3. ☐ Cables clear of Motion Base feet [pinch hazard]
  4. ☐ Left Touch Controller mounted [left side]

 Laptop

  1. ☐ Oculus app running [minimized]
  2. ☐ Sim configuration selected
  3. ☐ Controllers functioning in Controller Utility
  4. ☐ Close unnecessary software [if any]
  5. ☐ Launch and calibrate simulator!